Q: stainless steel will rust it?

A: normal use, the stainless steel sink is not rusty, but if the sink are used improperly, the surface will sink a "floating rust" or "albuginea" phenomenon. This is due to the use of water channels did not thoroughly washed, dirt caused by the surface adhesion, we must maintain the sink clean, there is no danger of rusting. When inadvertently sink also "rusty", may be affixed to the body wall basin special tips to deal with.

Q: What are the characteristics of embossed board

A: plate embossed stainless steel sheet in the ordinary pattern formed the basis of suppression. Embossed boards bold bright appearance, higher surface hardness, more wear-resistant. Of course, the price of materials is also very high.

Q: Why is stainless steel magnetic?

A: Stainless steel sheet itself is not magnetic, but stretching into a basin in the process of sheet metal crystal structure by high-pressure extrusion deformation, will produce a small amount of martensite structures that there was a slight magnetic and tensile deformation Large areas will be greater magnetic. Therefore, the basin will be part of the tensile body with little magnetic, especially the four largest fillet tensile deformation, also slightly magnetic. The panel is not the tensile deformation, almost non-magnetic. Some of the products currently on the market is not magnetic because the magnetic treatment after delinking.

Q: rust floating floor is not the quality problem?

A: not quality issues, and more room for the new decoration of metal pipes with residual impurities resulting from siltation in the pelvic floor. Toothpaste or powder can be used to clean, normal use will disappear naturally. Note: stainless steel sink in the use of generally do not use a strong disinfectant to sterilize the surface of stainless steel so as to avoid damage.

Q: Why does water sink to the very important parts?

A: As China washing large family kitchen, a large number of washing before eating a lot of meal preparation and cleaning utensils will have brought about a result of washing water slag debris, oil water. If the device only to water when washing water and washing water after the function is not least squares of the debris in the water, which would result in poor drainage pipes and cause blockage. So choosing a good sink to the water device is very important.

Q: Why should I use PP pieces of material to do the drain?

A: PP material is a kind of good material, it has extrusion resistance, high temperature, anti-aging properties and pipe fittings between good connectivity. General plastic pipe fittings especially intolerant of hot water hose, easy-aging interface easy to fall off and leakage. So there is absolutely can not be used to make water pipe connection, otherwise, they will spend more money to repair and replacement of kitchen cabinets.

Q: Does sink deeper as possible?

A: sink is not the harder the better. When washing, with little water filled the needs of basin body too deep, filled water is a waste of water resources, and time-consuming, water will be released dissatisfaction big bend. But if the tank had shallow water would lead to anti-splash. Therefore, the domestic water tank is normally 180-210mm appropriate.